MakerBot Replicator+ 3D Printer

MakerBot Replicator+ 3D Printer

The MakerBot Replicator+ 3D Printer is a giant among all 3D printers available in the market. Being a huge model it works quite efficiently and gives excellent print quality. In this article, I have covered each and everything about this 3d printer. So, it is recommended to read the full article before making any decision.

Product Specification

  • Printer Type: Fused Deposition Modelling (FDM)
  • Supported Material: PLA
  • Build Volume: 25.2cm x 19.9cm x 15cm
  • Print Volume: 11.6” x 7.6” x 6.3”
  • Minimum Layer Height: 100 microns
  • Extruder Included: 1
  • XY(axis) Precision: 11 microns
  • Included Heated Platform: NO
  • On Printer Control: YES
  • Connection Supported: WiFi, USB, Ethernet

Product Overview

This Replicator is no doubt a decent printer; there are lots of upgrades from the 5th generation models.  The upgrades in design by Makerbot are stunning, with the same metallic skeleton and greyish plastic frame. It is advertised to have 30% more printing speed and 22% more build volume.

Dominating Features

You’ll discover a 3-inch LCD over the Replicator+ along with the combination of button and dial that enable the user to control printer’s majority features. Beside this is a card reader or USB port for USB thumb drives for printing easily. Furthermore, the Replicator+ incorporates Wi-Fi and Ethernet associations that enable it to join your nearby system for printing from PCs, Macs and cell phones. A little webcam is additionally included, pointing down onto the printing zone so you can screen a print remotely to see when it is finished.

Setup

The setup is very simple and straightforward process. Just Unpack the printer load the filament and let the printer to install the necessary firmware updates.  Connect it with the wireless network through the mobile app. And that’s it! The printer is ready to print.

Printing Speed

As it is advertised, it is excellent in printing speed. In speed test it took almost 1 hour and 46 minutes for low-quality print and for high-quality print it took almost 6 hours and 8 minutes. The similar Giant printer TAZ 6 did the same job in 2 hours and 34 minutes and 7 hours and 58 minutes respectively.

Versatility

This Replicator can be controlled through the device itself or by an iOS or Android app or by a program running on Mac or PC. You can start/stop, change setting or monitor the printing process by Button located on printer with the 3-inch large LCD.

Controls

  • On PC or Mac: you can control it through the free available Makerbot Print Software.
  • On Android or iOS: You can control it through an app.
thumbs-up-icon

Pros

  • Huge 3D printer
  • Excellent print quality
  • Simple to operate and setup
  • Excellent software
  • Very versatile
  • Speedier than others
thumbs-down-icon

Cons

  • Some print glitches
  • Little bit expensive
  • Doesn’t support third-party filament

Conclusion

Despite a couple of bad things about this Makerbot Replicator+ 3D printer it turned out strong and got too many positive reviews. There are many dominating features that make this product reliable.It give nice printing speed, good print quality and top quality software suite.

We highly recommend this product!

Leave a Comment

0 Shares
Share
+1
Pin
Tweet